Key Points
- Purge Lines of Extracts
- Power Off & Depressurize
- Cleaning System
The Xylem X4 produced fully filled vaporizer with the press of a button – with parts handling filling and capping occurring within the machine.
Highlights
00:06
Remove any remaining extract from the lines and into a glass container beneath the syringe of Pump 1.
00:26
Power off both the Xylem X4 and the air compressor and release the air pressure valve on the Xylem X4 allowing the system to depressurize.
00:37
Be sure to clean the turn table and the inside of each of the turrets using ethanol to remove any residual extracts.
The Xylem X4 cartridge production system must be cleaned at the end of each production run. Any and all extract that may have spilled should be removed using ethanol.
Never leave the Xylem X4 vernight without being cleaned after use.
These simple cleaning steps will allow the Xylem X4 to perform at optimal speeds.